OXVA Xlim EZ Pods

OXVA Xlim EZ pods are refillable XL cartridges with built-in mesh coils. They hold more juice than standard Xlim pods, and the coil's already in there so you just bin the whole pod when the flavour goes. Four resistance options from 0.4Ω through to 1.2Ω cover everything from a loose RDL draw to a tight MTL pull.

They fit pretty much every kit in the Xlim range apart from the Xlim C. Top fill port on each one, leak resistant build, and they work with nic salts, 50/50, and high VG juice. Each box has three pods.

Key Features

• XL Capacity more juice, fewer refills
• Built-In Mesh Coils swap the whole pod, no coil changes
• Four Resistances 0.4Ω, 0.6Ω, 0.8Ω, 1.2Ω
• Top Fill refill without pulling the pod out
• Leak Resistant sealed build, no spills
• MTL and RDL tight draws or loose hits
• Colour Coded red, black, orange, green by resistance
• 3 Pack three pods per box

Xlim EZ Pod Resistance Options

Each resistance has a different draw and wattage range. The colour coding on each pod makes it easy to tell them apart.

The 0.8Ω and 1.2Ω are what most people go for if they're vaping nic salts. The 1.2Ω gives you that tight cigarette-style draw that suits higher strength salts. If you're on freebase juice and want more vapour, the 0.4Ω or 0.6Ω are the ones to grab.

For a full breakdown on vaping styles, our MTL vs DTL vs RDL guide covers the differences.

Built-In Mesh Coils

The coil sits inside the pod and you can't take it out. When flavour starts tailing off, you chuck the pod and click a fresh one in. No fiddling with separate coil heads, no priming wires, none of that.

The mesh coil heats your juice more evenly than a standard round wire coil would. You get better flavour from the first fill, and the coils tend to last a decent stretch before they need swapping. How long exactly depends on what juice you're running and how often you vape, but sweeter flavours will always gunk a coil up faster than menthol or tobacco.

For tips on getting more life out of your pods, have a look at choosing between 0.6 and 0.8 Xlim pods.

Top Fill

Snap the mouthpiece off the top of the pod and you'll see the fill port. Add your juice, then clip the mouthpiece back on until it clicks into place. You don't need to take the pod out of the kit to do it.

If you're filling for the first time, leave the pod to soak for a couple of minutes before you start vaping. That gives the cotton time to wick up properly and stops any dry hits on the first few puffs.

Xlim EZ Pod Compatibility

OXVA Xlim EZ pods work with nearly every kit in the Xlim range. Here's the full list.

Note: The 0.4Ω pods don't work with the Xlim SE, Xlim SQ, or Xlim V2 kits. All other resistances fit the lot.

Browse the full OXVA Xlim range to see every kit in the series.

What's in the Box?

• 3 x OXVA Xlim EZ Pods